Adjusting a Garage Door Repair Azle TX can be a bit tricky, but it’s essential to ensure that your door is operating smoothly and safely. A poorly adjusted door can cause damage to your property, pose a safety risk to your family, and decrease your home’s energy efficiency.
Here is a Step-by-Step guide on how to adjust your Garage Door Repair Azle TX:
- Inspect the Door
Before making any adjustments, inspect the garage door for damage, wear, and tear. Check the hinges, rollers, cables, and springs to see if they are in good condition. If any parts are damaged or worn, it’s best to replace them first before proceeding with adjustments.
- Check the Balance of the Door
A balanced door is essential for smooth operation. To test the balance, close the door and disconnect the opener by pulling the release cord. Lift the door manually to about halfway and release it. If the door stays in place, it’s balanced. If it falls or rises, it needs balancing.
To balance the door, adjust the tension on the springs. Most garage doors have two types of springs, extension and torsion. Extension springs are located above the tracks, while torsion springs are above the door. Adjusting the tension on torsion springs is dangerous, so it’s best to leave it to a professional. However, adjusting the tension on extension springs is relatively safe.
To adjust the tension on extension springs, use a winding bar to turn the spring in the direction that tightens it. Start with half a turn, and then test the door’s balance. Keep adjusting until the door stays in place when released.
- Adjust the Track
The track is the metal rail that the door runs on. If the track is not aligned correctly, the door may not open or close correctly. To adjust the track, use a level to check if it’s level both vertically and horizontally.
To adjust the track, loosen the bolts that hold it in place. Use a rubber mallet to tap the track into the correct position. Tighten the bolts again to secure the track in place.
- Lubricate the Moving Parts
Lubricating the moving parts of the garage door is essential for smooth operation. Apply a silicone-based lubricant to the hinges, rollers, springs, and track. Do not use WD-40 or other oil-based lubricants as they can attract dirt and dust.
- Adjust the Limit Switch
The limit switch is a safety feature that prevents the door from opening or closing too far. If the switch is not set correctly, the door may not close or open all the way.
To adjust the limit switch, locate the switch on the side of the motor unit. Use a flathead screwdriver to adjust the up and down limits. Test the door to see if it’s closing and opening correctly.
- Test the Safety Features
Garage doors have safety features such as photo-eye sensors that prevent the door from closing if something is in the way. Test these safety features to ensure that they are working correctly. Place an object in the door’s path and test if the door reverses when it comes in contact with the object.
- Test the Door
After making adjustments, test the door to see if it’s opening and closing smoothly. If the door is still not operating correctly, repeat the steps above.
In conclusion, adjusting a garage door is essential to ensure that it’s operating smoothly and safely. If you are not comfortable making adjustments, it’s best to hire a professional to do it for you. A well-adjusted door can help prevent damage to your property, ensure your family’s safety, and increase your home’s energy efficiency.
Garage Door Experts of Azle
525 Commerce St #5, Azle, TX 76020, United States
1-817-518-4880