Fixing a garage door cable can be a challenging task, but with the right tools and knowledge, it can be done safely and effectively. A broken or malfunctioning garage door cable can be dangerous, so it’s important to take the necessary precautions and follow the proper steps to fix it.

In this guide, we will outline the steps involved in fixing a Garage Door Repair Southlake TX cable.

Before you begin, you will need a few tools, including:

  • Safety glasses
  • Work gloves
  • Pliers
  • Wrenches
  • Screwdrivers
  • Replacement cables

Step 1: Disconnect the power

Before you begin any repairs on your garage door, you must disconnect the power source to avoid any potential accidents. Locate the power source, usually located in the garage or near the opener, and disconnect it.

Step 2: Remove the broken cable

The first step in fixing a garage door cable is to remove the broken cable. Start by releasing the tension on the cable. You can do this by pulling the emergency release cord to disconnect the opener from the door. This will allow you to manually open and close the door. Once the tension is released, use pliers to remove the cable from the door and the drum.

Step 3: Install the new cable

Once the old cable is removed, it’s time to install the new cable. Start by threading the new cable through the bottom bracket of the door and up through the center of the spring. Be sure to leave enough slack in the cable to wrap around the drum several times. Next, insert the cable into the drum, making sure it’s seated properly.

Step 4: Wind the cable onto the drum

Now it’s time to wind the cable onto the drum. Using a wrench or pliers, turn the drum until the cable is tight around it. Make sure the cable is winding onto the drum evenly, and don’t forget to wind it in the same direction as the other cable.

Step 5: Reattach the cable to the door

Once the cable is wound onto the drum, reattach it to the door. Use pliers to loop the cable around the bottom bracket of the door, making sure it’s securely fastened. Repeat this process on the other side of the door.

Step 6: Reconnect the power

With the new cable installed, it’s time to reconnect the power. Test the door to make sure it’s working properly, and adjust the tension on the springs if necessary.

Step 7: Test the door

Before you finish, it’s important to test the door to ensure that it’s working properly. Open and close the door several times to make sure it’s moving smoothly and that the cables are not binding or catching on anything. If everything looks good, your garage door should be working as good as new.

In conclusion, fixing a Garage Door Repair Southlake TX cable requires some basic knowledge and tools, but it’s a job that can be done by anyone with a bit of DIY experience. By following these steps and taking the necessary safety precautions, you can fix a broken garage door cable and keep your garage door functioning properly for years to come.

Dragon Garage Door & Gates

351 Central Ave #7, Southlake, TX 76092, United States

1-817-587-0445