Replacing a Roanoke Garage Door Repair spring can be a daunting task, but with the right tools, preparation, and knowledge, it can be done safely and effectively.

In this guide, we will provide a step-by-step approach to replacing a garage door spring.

Step 1: Gather necessary tools and equipment

Before starting, gather the necessary tools and equipment for the job. These include:

  • A pair of winding bars
  • A wrench
  • A ladder
  • Safety glasses
  • New garage door springs
  • A tape measure
  • A level

Step 2: Release tension on the existing spring

The first step in replacing a garage door spring is to release the tension on the existing spring. This is important because the tension can cause injury or damage to the garage door or surrounding area if not properly released. To release the tension, follow these steps:

  1. Disengage the garage door opener by pulling the emergency release cord.
  2. Place a winding bar into one of the holes on the winding cone of the spring.
  3. Turn the winding bar counter-clockwise to release tension on the spring.
  4. Remove the winding bar and repeat on the other winding cone.

Step 3: Remove the old spring

Once the tension on the spring is released, you can remove the old spring. To do this, follow these steps:

  1. Use a wrench to remove the bolts holding the spring in place.
  2. Slide the spring off of the torsion tube.

Step 4: Measure the old spring and select a new one

Before selecting a new spring, you will need to measure the old one. This will ensure that the new spring is the correct size for your garage door. To measure the old spring, follow these steps:

  1. Measure the length of the spring, from end to end.
  2. Measure the diameter of the wire used in the spring.
  3. Count the number of coils in the spring.

Once you have these measurements, you can select a new spring that matches the old one.

Step 5: Install the new spring

To install the new spring, follow these steps:

  1. Slide the new spring onto the torsion tube.
  2. Secure the spring in place with the bolts.
  3. Use the winding bars to wind the spring in the opposite direction of the old spring. This will create tension on the new spring.
  4. Wind the spring until the coils are touching each other and the spring has the correct tension. This can be determined by using a level to ensure that the garage door is level when closed.

Step 6: Test the garage door

Once the new spring is installed, it is important to test the garage door to ensure that it is working properly. To do this, follow these steps:

  1. Reconnect the garage door opener.
  2. Open and close the garage door several times to ensure that it is working smoothly and without any issues.
  3. Check the balance of the garage door by disconnecting the opener and manually lifting the door. The door should lift smoothly and easily, without any resistance or unevenness.

Conclusion

Replacing a Roanoke Garage Door Repair spring requires careful attention to detail and a commitment to safety. By following these steps, you can replace your garage door spring safely and effectively, ensuring that your garage door functions properly and smoothly. If you are uncomfortable with any aspect of the process, it is always best to seek the assistance of a professional.

South Denton Overhead Garage Door

112 US-377 #9, Roanoke, TX 76262, United States

1-817-873-2942