Garage Door Repair Decatur TX springs play a crucial role in the proper functioning of your garage door. Over time, these springs can wear out and need replacement. If you have an old-style garage door with extension springs, this guide will walk you through the process of replacing them. Remember, safety should always be a top priority when working with garage door springs.

If you’re uncertain or uncomfortable performing the replacement yourself, it’s best to seek professional assistance.

Before You Begin:

  1. Gather the necessary tools: You’ll need a ladder, adjustable wrench, vise grips, safety glasses, winding bars, and new extension springs that match the specifications of your old ones.
  2. Disable the automatic opener: Unplug or disconnect the power source to the automatic opener to prevent accidental activation while you’re working on the springs.

Step 1: Release Tension from the Old Springs:

  1. Close the garage door completely.
  2. Place a ladder under the garage door tracks on one side, near the springs.
  3. Identify the safety cables: These are attached to the extension springs and run through the pulleys. Disconnect them from the brackets.
  4. Use the vise grips to clamp onto the track just above the bottom roller to prevent the door from opening unexpectedly.
  5. Insert a winding bar into the hole of the winding cone on the end of the spring.
  6. Slowly unwind the spring tension by turning the winding bar in the opposite direction of the winding cone.
  7. Once the tension is released, repeat the process for the second spring on the same side.

Step 2: Remove the Old Springs:

  1. With the tension released, loosen the set screws on the end brackets that hold the springs in place.
  2. Slide the springs off the brackets and carefully lower them down.
  3. Ensure you have a firm grip on the springs to prevent them from accidentally flying off.

Step 3: Install the New Springs:

  1. Start by attaching the new springs to the end brackets.
  2. Make sure the springs are oriented correctly with the winding cones facing towards the center of the door.
  3. Slide the springs onto the brackets and secure them with the set screws.
  4. Repeat the process for the second spring.

Step 4: Reapply Tension to the New Springs:

  1. Insert a winding bar into the hole of the winding cone on the end of the first spring.
  2. Begin winding the spring in the direction specified by the manufacturer, applying enough tension to counterbalance the weight of the garage door.
  3. Once the spring is wound, secure it with the set screws on the end bracket.
  4. Repeat the winding process for the second spring.

Step 5: Reattach the Safety Cables and Test:

  1. Reconnect the safety cables to the brackets, ensuring they are properly routed through the pulleys.
  2. Carefully remove the vise grips from the track.
  3. Slowly open and close the garage door to test the new springs’ functionality.
  4. Observe the door’s balance and motion to ensure smooth and even operation.

Conclusion: Replacing old-style Garage Door Repair Decatur TX springs requires caution and attention to detail. By following the steps outlined in this guide, you can safely replace the springs and restore your garage door’s functionality. Remember, if you are unsure or uncomfortable with the process, it is always best to seek professional assistance to ensure your safety and the proper installation of the springs.

Decatur Garage Door & Gates

300 S Trinity St, Decatur, TX 76234

940-202-7890