Clearing codes on a Genie Lancaster Garage Door Repair is a relatively simple process that can be accomplished in a few steps.

Clearing codes is often necessary when you want to reset the remote control or keypad, or when you’re dealing with a lost or stolen remote control. Here’s a step-by-step guide with detailed explanations to ensure you can clear the codes effectively:

: Gather Your Tools and Information

Before you start, make sure you have the following items ready:

  1. Genie garage door opener manual: This is your primary source of information for your specific model. It contains detailed instructions and may have model-specific variations.
  2. Ladder: To safely reach and access the garage door opener.
  3. Safety precautions: Ensure that the garage door is closed and no one is near the door while you’re working on it to avoid accidents.

: Access the Garage Door Opener Unit

Use your ladder to access the Genie garage door opener unit, which is typically mounted on the ceiling in your garage. Make sure the unit is turned off, and disconnect the power source if necessary for added safety.

: Locate the “Learn” or “Program” Button

Inside the opener unit, you should find a small button labeled “Learn” or “Program.” This button is usually near the antenna wire. The location of the button may vary depending on your model, so consult your manual if you’re unsure.

: Press the “Learn” or “Program” Button

Press and hold down the “Learn” or “Program” button for about 10-15 seconds. You may see a light or LED indicator on the unit start to blink or change color. This action erases all the stored codes in the opener’s memory.

: Release the Button

After holding the button for the specified duration, release it. The light or LED indicator should stop blinking or return to its normal state, indicating that the codes have been cleared.

: Reset Remotes and Keypads

Now that the opener’s memory is clear, you’ll need to reset your remote controls and keypads to reprogram them. The process may vary slightly depending on your remote or keypad model. Here’s a general guideline:

For Remotes:

  1. Hold the remote close to the opener unit.
  2. Press and release the remote control button that you want to reprogram.
  3. The opener unit’s light or LED indicator should blink, indicating that it’s received the new code.
  4. Test the remote to ensure it now operates the garage door as intended.

For Keypads:

  1. Follow your keypad’s manual to access the programming mode.
  2. Enter your desired PIN code following the instructions in the manual.
  3. Test the keypad to ensure it opens and closes the garage door properly.

: Reconnect Power and Test

After you’ve reset your remotes and keypads, reconnect the power source to the opener unit (if disconnected) and turn the unit back on. Test all your remotes and keypads to make sure they operate the garage door opener correctly.

: Record New Codes

It’s a good practice to record the new codes for your remotes and keypads in a safe place. This will be helpful in case you need to reprogram them in the future.

: Secure Your Opener

Ensure that your garage door opener unit is securely closed and protected from the elements.

: Consult Your Manual

Always refer to your Genie Lancaster Garage Door Repair manual for model-specific instructions and any additional steps that may be required for your particular unit. If you don’t have the manual, you can often find it online on the Genie website or contact their customer support for assistance.

By following these steps and consulting your specific Genie garage door opener manual, you should be able to clear the codes and reprogram your remotes and keypads with ease. Remember to prioritize safety throughout the process to prevent accidents or damage to your garage door opener.

Lancaster Garage & Overhead Doors

661-232-0154