Aligning garage door sensors can be a simple task that you can do by yourself.

Here are the steps you can follow according to Princeton Garage Door:

  1. Locate the sensors: Typically, garage door sensors are located on the sides of the garage door, around 6 inches above the ground. Each sensor consists of a small box that houses a transmitter and a receiver.
  2. Check for obstructions: Make sure there are no obstructions in front of the sensors, such as debris or tools. Also, make sure the lenses of the sensors are clean and free of dirt or grime.
  3. Check the alignment: Look at the alignment of the sensors. The transmitter and receiver should be pointing directly at each other, and their lenses should be facing each other. Use a level or a straight edge to make sure they are aligned properly.
  4. Adjust the sensors: If the sensors are not aligned properly, you can adjust them by loosening the screws that hold them in place. Move the sensors until they are aligned, then tighten the screws again. Check the alignment again using a level or a straight edge.
  5. Test the sensors: Test the sensors by opening and closing the garage door. If the sensors are properly aligned, the door should open and close smoothly. If the door doesn’t close or keeps reversing, the sensors may need further adjustment.
  6. Repeat if necessary: If the door still doesn’t close properly, repeat the process until the sensors are aligned correctly.

In summary, as stated in Princeton Garage Door, remember to follow safety precautions when working with garage doors. If you’re not comfortable with adjusting the sensors or if you’re unsure about anything, it’s best to seek the help of a professional.

Princeton Garage Door Experts

114 N 2nd St #5, Princeton, TX 75407, United States

469-281-7310