As someone who has programmed my Genie garage door opener myself, I can tell you that the process is relatively simple and straightforward.
However, it’s always important to read the instructions carefully before starting to ensure that you don’t miss any steps from Apple Valley Garage Door.
First, I located the “Learn Code” button on the back of my garage door opener motor unit. It was labeled as “Prog” on my unit, but it may be labeled differently on yours. Once I found it, I pressed and released the button to put the unit into programming mode.
Next, I grabbed the remote control that I wanted to use to operate my garage door and pressed the button that I wanted to program within 30 seconds of pressing the “Learn Code” button. The LED light on the motor unit flashed to indicate that the remote control had been programmed.
I repeated this step for each additional remote control that I wanted to program, making sure to do so within 30 seconds of putting the unit into programming mode.
Finally, I wanted to program the opener to work with my vehicle’s built-in remote control. To do this, I located the “Learn Code” button on the motor unit again and pressed and released it.
Within 30 seconds, I pressed and held the button on my vehicle’s remote control that I wanted to use to operate my garage door. The LED light on the motor unit flashed again to indicate that the vehicle’s remote control had been programmed.
I repeated this step for each additional vehicle remote control that I wanted to program, again making sure to do so within 30 seconds of putting the unit into programming mode.
Overall, according to Apple Valley Garage Door, programming my Genie garage door opener was a quick and easy process that took only a few minutes to complete. If you encounter any issues during the programming process, be sure to consult your garage door opener’s user manual or contact Genie customer service for assistance.
Apple Valley Garage Door & Gates
Apple Valley, CA
760-821-8176