Programming a Wayne Dalton Garage Door Repair Chandler, AZ opener is a relatively simple process that can be completed in a few easy steps.

However, it is important to ensure that you have the necessary equipment and follow the instructions carefully to ensure that the programming is successful.

Step 1: Gather the Necessary Equipment

To program your Wayne Dalton garage door opener, you will need the following equipment:

  • A ladder to access the garage door opener motor unit
  • A Wayne Dalton remote control
  • A new battery for the remote control
  • A small flat-head screwdriver
  • A step stool or chair (optional)

Step 2: Locate the Motor Unit

The motor unit for your Wayne Dalton garage door opener is typically located on the ceiling of your garage. Use a ladder or step stool to access the unit.

Step 3: Locate the Programming Button

On the motor unit, locate the “Program” button. This button is usually located near the “Open/Close” button and may be labeled “P” or “Prog.”

Step 4: Press and Release the Programming Button

Using the small flat-head screwdriver, press and release the “Program” button on the motor unit. You should see a light on the motor unit flash, indicating that the programming mode has been activated.

Step 5: Program the Remote Control

Press and release the button on your Wayne Dalton remote control that you want to program. Hold the remote control within a foot of the motor unit while you do this. You should see the light on the motor unit flash again, indicating that the programming was successful.

Step 6: Test the Remote Control

To ensure that the programming was successful, test the remote control by pressing the button that you programmed. The garage door should open or close in response to the command.

Step 7: Repeat the Process for Additional Remote Controls

If you have additional Wayne Dalton remote controls that you want to program, repeat steps 5 and 6 for each one.

Step 8: Exit Programming Mode

Once you have programmed all of your remote controls, press and release the “Program” button on the motor unit again to exit programming mode. The light on the motor unit should stop flashing.

In conclusion, programming a Wayne Dalton Garage Door Repair Chandler, AZ opener is a straightforward process that can be completed in a few easy steps. By following these instructions carefully and ensuring that you have the necessary equipment, you can program your remote control and start using your garage door opener with ease.

Acclaim Garage Door of Chandler AZ

184 E Chilton Dr, Chandler, AZ 85225, United States

1-480-545-0538