Garage door springs play an essential role in the operation of your garage door. They are responsible for supporting the weight of the door and providing the necessary tension for the opener to lift and lower the door. When a garage door spring breaks or becomes damaged, it can cause the door to malfunction and become a safety hazard.

In this guide, we will discuss how to repair garage door springs.

Before we begin, it is important to note that Garage Door Repair Decatur TX springs are under a significant amount of tension and can be dangerous to handle. If you are not comfortable working with garage door springs or do not have the necessary tools, it is best to call a professional for assistance.

Step 1: Identify the type of garage door spring

There are two main types of garage door springs: torsion and extension. Torsion springs are located above the garage door and are wound tightly to provide the necessary tension. Extension springs are located on either side of the door and stretch to provide tension. It is important to identify which type of spring you have before attempting any repairs.

Step 2: Gather necessary tools and supplies

To repair a garage door spring, you will need the following tools and supplies:

  • Safety glasses
  • Leather gloves
  • Vice grips
  • Adjustable wrench
  • Winding bars
  • Replacement springs
  • Socket set

Step 3: Release the tension on the garage door spring

Before attempting any repairs, it is important to release the tension on the garage door spring. This can be done by disconnecting the opener and manually lifting the door until the spring is fully extended.

Step 4: Remove the old spring

Once the tension is released, you can remove the old spring. For a torsion spring, use a winding bar to loosen the set screws and slide the spring off the shaft. For an extension spring, use vice grips to clamp onto the spring and remove the safety cable. Then, use a socket set to remove the spring from the pulley system.

Step 5: Install the new spring

After removing the old spring, it is time to install the new spring. Start by installing the new spring onto the pulley system or shaft, depending on the type of spring you have. For a torsion spring, wind the new spring tightly using the winding bars and tighten the set screws. For an extension spring, attach the safety cable and tighten the screws.

Step 6: Test the garage door

Once the new spring is installed, it is important to test the garage door to ensure it is working properly. Reconnect the opener and lift the door manually to ensure it is balanced and operating smoothly. If there are any issues, make any necessary adjustments and retest.

Step 7: Repeat for the other spring (if applicable)

If your garage door has two springs, it is important to replace both springs at the same time to ensure balanced tension. Repeat the above steps for the other spring.

In conclusion, repairing a Garage Door Repair Decatur TX spring can be a challenging task that requires the right tools and knowledge. If you are not comfortable handling garage door springs or do not have the necessary tools, it is best to call a professional for assistance. However, if you do decide to tackle this repair yourself, be sure to follow the above steps carefully to ensure a safe and successful repair.

Decatur’s Best Garage Door

248 Private Rd 1377, Alvord, TX 76225, United States

1-940-242-3016