Here’s how I programmed the garage door opener for my Toyota Camry according to Garage Door Repair Miami Gardens FL:
First, I cleared any previously programmed garage door openers from my Camry’s memory by pressing and holding the two outer buttons on the Homelink® system located on the overhead console of my vehicle for about 20 seconds. The LED indicator flashed slowly and then rapidly to indicate that the codes had been cleared.
Next, I held my garage door opener’s remote control near the Homelink® buttons and pressed and held the button I wanted to program. Once the LED light on the Homelink® system started flashing rapidly, I released both the Homelink® button and the button on my garage door remote simultaneously.
Then, I pressed and held the programmed Homelink® button until the LED light on the Homelink® system changed from a slow flash to a rapid flash. This took about 10-20 seconds.
With the LED light flashing rapidly, I pressed the learn button on my garage door opener motor unit, which is usually located near the light bulb and may be labeled “Learn,” “Program,” or “Set.”
Quickly returning to my Camry, I pressed and held the Homelink® button I just programmed for two seconds. The LED light changed from a rapid flash to a solid light, indicating that the programming was complete.
Finally, I tested the programming by pressing the Homelink® button I just programmed, and my garage door opened as expected.
Overall, as stated in Garage Door Repair Miami Gardens FL, programming the garage door opener for my Toyota Camry was a straightforward process that only took a few minutes.
Denzel’s Garage Door of Miami Gardens
17820 NW 27th Ave #5, Miami Gardens, FL 33056, United States
786-509-5409