Replacing a Garage Door Repair spring is a task that requires caution and attention to detail. It is important to follow the necessary steps to ensure your safety and the proper functioning of the garage door.

Here’s a step-by-step guide on how to replace a garage door spring:

  1. Safety First:
    • Put on safety goggles and work gloves to protect your eyes and hands.
    • Make sure to disconnect the power to the garage door opener to prevent any accidental activation while you’re working.
  2. Identify the Type of Spring:
    • There are two main types of garage door springs: torsion springs and extension springs. Determine which type your garage door has, as the replacement process varies for each.
  3. Gather the Necessary Tools:
    • Before you begin, gather all the tools you’ll need, which may include wrenches, pliers, winding bars, and a ladder.
  4. Release Tension on Torsion Springs:
    • For torsion springs, start by releasing the tension on the existing spring. Insert a winding bar into one of the winding cone holes and carefully loosen the set screws. Slowly unwind the spring until the tension is fully released.
  5. Remove the Old Spring:
    • Once the tension is released, disconnect the spring from the center bracket and slide it out from the torsion tube. Be cautious as the spring may still have some residual tension.
  6. Install the New Spring:
    • Install the new spring by sliding it onto the torsion tube and connecting it to the center bracket. Ensure that the spring is properly centered and aligned.
  7. Wind the Torsion Spring:
    • Use the winding bars to wind the torsion spring. Insert the winding bar into one of the winding cone holes and apply a controlled force to wind the spring. Follow the manufacturer’s instructions for the specific number of turns required based on the weight of your garage door.
  8. Secure the Torsion Spring:
    • Once the torsion spring is properly wound, tighten the set screws on the winding cones to secure it in place. Double-check that the spring is balanced and centered.
  9. Replace Extension Springs:
    • For extension springs, start by disconnecting them from the pulley system and track hangers. Carefully remove the old springs from the pulleys and track hangers.
  10. Install the New Extension Springs:
    • Install the new extension springs by attaching them to the pulleys and track hangers. Ensure they are properly seated and under tension.
  11. Test the Garage Door:
    • After replacing the spring, carefully raise and lower the garage door manually a few times to check its balance and smooth operation. Make any necessary adjustments if the door is not opening or closing properly.
  12. Reconnect the Garage Door Opener:
    • Once you have confirmed that the garage door is functioning correctly, reconnect the power to the garage door opener and test the door’s operation using the opener.

Remember, if you are unsure about any step or if the task seems too challenging, it is recommended to seek professional assistance to ensure your safety and the proper functioning of the Garage Door Repair.

Overhead Raleigh Doors

Raleigh, NC

1-919-500-1112