Resetting a Vivint Garage Door Repair opener is a relatively simple process that can be done following a few steps.

It’s important to note that the exact steps may vary depending on the model of your Vivint garage door opener. In general, however, the following instructions should guide you through the process.

  1. Identify the garage door opener model: Start by locating the model number of your Vivint garage door opener. This information can typically be found on the device itself or in the user manual that came with it. Knowing the model number will help you find specific instructions for your particular opener.
  2. Disconnect power: Before resetting the garage door opener, it’s crucial to disconnect the power supply to ensure your safety. Locate the power cord of the opener and unplug it from the electrical outlet. If your opener is hardwired, you may need to turn off the circuit breaker that supplies power to the opener.
  3. Locate the reset button: Look for the reset button on your Vivint garage door opener. It is usually located near the motor unit or control panel. The button may be labeled as “Reset” or have a small hole that requires a paperclip or a similar tool to press it.
  4. Press and hold the reset button: Using your finger or a suitable tool, press and hold the reset button for about 10-15 seconds. This action will reset the garage door opener’s settings and clear any stored configurations.
  5. Release the reset button: After holding the reset button for the specified time, release it. You may notice some indicators, such as lights flashing or the motor unit making a sound. These are typical indications that the reset process is in progress.
  6. Restore power: Once you have released the reset button, restore power to the garage door opener. Plug the power cord back into the electrical outlet or turn on the circuit breaker if it was previously turned off.
  7. Reprogram remote controls: After resetting the garage door opener, you will likely need to reprogram any remote controls or keypads that were previously connected to the system. Consult your user manual for instructions on how to program these devices. The process usually involves pressing a combination of buttons on the remote control or keypad and then syncing them with the opener.
  8. Test the garage door: Once you have reprogrammed the remote controls, test the garage door to ensure it functions properly. Press the appropriate button on the remote control to open or close the door. If the door operates correctly, the reset process was successful.
  9. Adjust settings if needed: If you find that certain settings, such as the travel limits or force settings, need adjustment after the reset, consult the user manual for instructions on how to make these changes. Each model of Vivint garage door opener may have specific methods for adjusting these settings.

Remember to consult the user manual provided by Vivint for your specific Garage Door Repair opener model, as the steps mentioned above are general guidelines. Following the manufacturer’s instructions will ensure that you reset your Vivint garage door opener correctly and safely.

BH Garage Doors and Gates

Rockwall, TX

1-972-807-7936